|# of Parts:||0|
|Value of Parts:||0.00|
Rim lock nut needs to be ordered separately, part no. 77110090050.
Rim lock nut needs to be ordered seperately, part no. 77110090050
Replacement filter for original paper element. Improved filtration & is fully serviceable.
Pre-Cleaner foams for use with original air box. Easy to install. Provides extra filtration, improves air box sealing. Designed to be used with Unifilter AU1417.
This filter offers more surface area for increased dirt holding and longer service intervals.
Supplied as a pack of 3.
KTM 690 / Husqvarna 701 Enduro Air Box Pre-Cleaner Kit
This kit replaces the top half of the air box.
Kit includes 2 x Pre-Filter Foams, 1 x Powder-coated Air Box Bracket, Inner Support Frame.
Filters supplied Pre-oiled.
**AU1440 DOES NOT INCLUDE the Air filter, if you need order AU1417 as well.
SUB Mount / Complete Stabilizer Kit / rubber type/ using stock triple clamp (rubber type SUB mount)
This shows the RUBBER SUB mount, (Stabilizer Under Bars), mounted on the stock triple clamps. The rubber mounting system defuses vibration and rider fatigue by incorporating flexible rubber mounts as part of the handlebar clamps while at the same time housing the stabilizer. This mounting system raises the bars approximately 15mm and positions the stabilizer under the bars allowing more room for other items on the bars and the adaption of a standard bar pad, if so desired. The complete kit includes the sub mount, extra different-density cones, stabilizer, link-arm, frame bracket, tower pin, all necessary hardware, plus detailed instructions for easy installation.
High grade billet aluminium and extra wide foot pegs for Husqvarna 701 Enduro and 710RR Adventure.
These high quality foot pegs take the pressure of your feet and your boots, more surface area for comfort on long rides.
Properly inflated tyres save you money. Maintaining correct tyre pressures reduces fuel consumption and maximises tyre life. Best of all, the process is made easy by using the MotoPressor” Digital Tyre Gauge!!
There is no need to hold MotoPressor” Digital Tyre Gauge on the valve to read the Tyre pressure.
Press the POWER button to turn the unit on.
Continue pressing the POWER button until the correct scale appears either psi, bar, kpa or Kg/cm2.
Push the gauge onto the valve firmly and hold it in place for approximately 2-3 seconds.
Remove and read the tire pressure. The Tyre pressure will display for 10 seconds and then zero itself.
The unit will power OFF automatically after 30 seconds.
The MotoPressor” Digital Tyre Gauge comes with batteries installed, ready to go.
This handy little gauge weighs just 48g and small is enough to reach those “hard to get at” valves.